GEO5 Catalog

This program is used for the design of cantilever retaining walls. It offers a variety of wall shapes.

This program is used for the analysis and design of mechanically stabilized earth (MSE) walls and segmental retaining walls reinforced by geogrids ...

This program is used to design gabion walls. It allows analysis of many structure shapes including overhangs requiring anchoring.

This program is used for the design of reinforced masonry block walls.

This program is used to analyze the stability of rock slopes and walls for a specified type of failure, including a planar or polygonal slip surfac...

This program is used for designing advanced retaining walls using the Redi-Rock wall system (USA). The GEO5 Redi-Rock Wall allows full integration ...

This program is used for the design of retaining walls made of prefabricated blocks.

This program is used to design soil nail walls and slopes of various shapes with shotcrete cover or steel mesh.

This program is used for the design of pile walls stabilizing slope movement or increasing the safety factor of the slope. The initial analysis sho...

This program computes earth pressures acting upon an arbitrarily shaped structure;?ÿactive pressure, passive pressure, and pressure at rest.

This program is used for the analysis and design of spread footings such as spread or strip footing subject to general load. It computes vertical a...

This program is used for the analysis and design of spread footings such as spread or strip footings subject to general load, and based on data fro...

This program is used for the analysis and design of the vertical and horizontal bearing capacity of a single pile loaded both in tension or compres...

This program is used for the analysis and design of steel tube micropiles. When calculating the micropile bearing capacity, the program verifies bo...

This program is used for the analysis and design of a pile group (pile raft foundation with a rigid pile cap) using both the spring method (FEM) an...

This program is used to analyze and design the vertical and horizontal bearing capacity of a single pile loaded in tension or compression. It compu...

This program provides the analysis and design of foundation beams resting on the elastic subgrade.?ÿ

The program Slab is used for the analysis and design of arbitrary-shaped foundation mats and slabs on elastic subsoil, using the Finite Element Met...

This program is used to determine vertical settlement and time-dependent consolidation of soils under embankments, foundations, earth dams, and sur...

This program is used for the analysis and design of bridge abutments including wing walls. It allows checking the abutment for overturning, transla...

This program is used to analyze spatial earth pressures on circular shafts and determination of internal forces on the structure.

This program is used for analysis and determining surface ground settlement induced by subsurface cavities such as tunnels, large sewer systems, an...

GEO5 Slope Stability is used to perform slope stability analysis (embankments, earth cuts, anchored retaining structures, MSE walls, etc.). The sli...