Products

This program provides the analysis and design of foundation beams resting on the elastic subgrade.?ÿ

This program is used for the analysis and design of bridge abutments including wing walls. It allows checking the abutment for overturning, transla...

This program is used for the design of pile walls stabilizing slope movement or increasing the safety factor of the slope. The initial analysis sho...

GEO5 Basic package is a geotechnical software suite that included over 20 programs used for the analysis and design of virtually all practical geot...

This program is used for the design of cantilever retaining walls. It offers a variety of wall shapes.

This program computes earth pressures acting upon an arbitrarily shaped structure;?ÿactive pressure, passive pressure, and pressure at rest.

GEO5 Excavation package is a group of GEO5 programs used for the analysis and design of shoring/excavation problems. The package includes Sheeting ...

The Finite Element Method (FEM) program is used for modeling and analysis of a wide range of geotechnical problems, including terrain settlement, s...

The FEM Consolidation add-on requires FEM (Proper) as the underlying program.The FEM Consolidation is used for the analysis of time-dependent settl...

The FEM Earthquaqe add-on requires FEM (Proper) as the underlying program. The FEM Earthquake is used for the dynamic analysis of geotechnical stru...

The FEM Tunnel add-on requires FEM (Proper) as the underlying program. The FEM Tunnel is used for the analysis and design of tunnels. It includes s...

The FEM Water Flow add-on requires FEM (Proper) as the underlying program. The FEM Water Flow is used for the analysis of steady-state or transient...

The GEO5 Foundation Package is a group of GEO5 programs used for the analysis and design of shallow and deep foundations.

This program is used to design gabion walls. It allows analysis of many structure shapes including overhangs requiring anchoring.

The GEO5 Geology package is used for site characterization, producing logs, sections, and subsurface modeling. It includes. Stratigraphy (Proper), ...

This program is used for the design of gravity retaining walls. It offers a variety of wall shapes.

This program is used for analysis and determining surface ground settlement induced by subsurface cavities such as tunnels, large sewer systems, an...

Program Laboratory provides effective processing and analysis of laboratory tests of soils and rocks. The program is not only intended for laborato...

This program is used for the design of reinforced masonry block walls.

This program is used for the analysis and design of steel tube micropiles. When calculating the micropile bearing capacity, the program verifies bo...

This program is used for the analysis and design of mechanically stabilized earth (MSE) walls and segmental retaining walls reinforced by geogrids ...

This program is used to design soil nail walls and slopes of various shapes with shotcrete cover or steel mesh.

This program is used for the analysis and design of the vertical and horizontal bearing capacity of a single pile loaded both in tension or compres...

This program is used to analyze and design the vertical and horizontal bearing capacity of a single pile loaded in tension or compression. It compu...